Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
The engine speed (RPM) must be higher than 1,500 rpm. Load above 10 grams per second. The engine coolant temperature (ECT) must be below 50°C. Diagnostic trouble code (DTC) ECM-120A is stored if the control module registers that the temperature of the intake air is more than 60deg;C for approximately 15 seconds.
Substitute value
30°C
Possible source
Faulty signal:
- defective intake air temperature (IAT) sensor internally in the mass air flow (MAF) sensor
- contact resistance in the connectors.
Fault symptom[s]
None.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.