Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.4L VIN 64 B5244S6REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSCEM CODES (CENTRAL ELECTRONIC MODULE)CEM-DF14PERMANENT FAULTDIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo V70 L5-2.4L VIN 64 B5244S6
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information CEM-DF14
Condition
Diagnostic trouble codes (DTCs) are stored if the central electronic module (CEM) registers that there is a short-circuit to ground in the CAN L in the high speed network.
Note! In the event of DFxx diagnostic trouble codes (DTCs), the central electronic module (CEM) must not be replace as the diagnostic trouble code (DTC) indicates a short-circuit in one or more conductors in the Control area network! The central electronic module (CEM) is the only control module that monitors the voltage level in the Control area network wiring. The central electronic module (CEM) is therefore the only control module that can store a diagnostic trouble code (DTC) for a short-circuit in one of the cables to ground or supply voltage. Do not replace the central electronic module (CEM) in the event of a CAN fault unless VIDA fault-tracing has indicated that the central electronic module (CEM) has an internal fault.
Substitute value
None.
Possible source
- Short-circuit to ground in the high speed network.
Fault symptom[s]
- Radio interference.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.