Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.4L VIN 64 B5244S6REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSCEM CODES (CENTRAL ELECTRONIC MODULE)CEM-8F1CDIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo V70 L5-2.4L VIN 64 B5244S6
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
The central electronic module checks the signal from the right Xenon lamp.
Diagnostic trouble code (DTC) CEM-8F1C is stored in the central electrical module if the central electronic module registers too high a signal from the right Xenon lamp.
Diagnostic trouble code (DTC) CEM-8F1C can be detected when the ignition is on for at least 10 seconds and the battery voltage is > 10.5 volts.
Substitute value
- None.
Possible source
- Short-circuit to supply voltage in the signal cable
- Open-circuit in the signal cable
- The actuator motor in the xenon lamp housing has jammed
- Defective actuator motor in the xenon lamp housing.
Fault symptom[s]
- The low beam is constantly lit
- The high beam is constantly lit
- The road surface is not illuminated.
- Headlights/Headlight aim is off
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.