Diagnostic Trouble Code (DTC) Information

2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Diagnostic Trouble Code (DTC) Information





Diagnostic trouble code (DTC) information

Condition
Diagnostic trouble code (DTC) CEM-2E01 is stored if the control module registers that the signal in one or more of the four outputs is too high, too low, or missing when the ignition is in position II or when the engine speed is higher than 500 rpm.

Substitute value
None

Possible source
- The power stage is disabled until the fault has disappeared The engine cannot be checked.
- Short-circuit to supply voltage, to ground or open-circuit in one or more of the four outputs.

Fault symptom[s]
- The servo control does not operate.
- Warning lamp in the combined instrument panel lit.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.