Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.4L VIN 64 B5244S6REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSCCM CODES (CLIMATE CONTROL MODULE)CCM-0002DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo V70 L5-2.4L VIN 64 B5244S6
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
Diagnostic trouble code (DTC) CCM-0002 is stored if the control module registers that the diagnostic signal from the blower fan power unit is above 10 V and the control current to the blower fan power unit is above 8.56 mA.
Substitute value
- The blower fan cannot start while the fault persists
- The air conditioning (A/C) compressor is not allowed to start.
Possible source
- Blocked blower fan motor
- Open-circuit in the signal cable
- Open-circuit in the ground lead for the fan motor
- Short-circuit to supply voltage in the ground lead for the blower fan motor
- Short-circuit to ground in the control signal cable
- Open-circuit in the control signal cable
- Short-circuit to supply voltage in the diagnostic signal cable
- Defective blower fan motor or power unit
- Contact resistance.
Fault symptom[s]
- The blower fan does not operate
- Air flow problem
- No cooling from the air conditioning (A/C) system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.