Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.4L VIN 64 B5244S6REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSBCM CODES (BRAKE CONTROL MODULE)BCM-A031PLAUSIBILITY CHECK NOT RUN
2004 Volvo V70 L5-2.4L VIN 64 B5244S6
Plausibility Check Not Run
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Plausibility Check Not Run
Plausibility check not run
Checking diagnostic trouble codes (DTCs)
If diagnostic trouble code (DTC) BCM-A031 is stored on its own it must be erased.
If diagnostic trouble code (DTC) BCM-0111 is stored at the same time as BCM-A031, read off the diagnostic trouble codes (DTCs) from the control module for the steering angle sensor. Fault-trace the system.
Select an option:
1. Diagnostic trouble code (DTC) BCM-A031 is stored on its own
2. Diagnostic trouble codes (DTCs) BCM-0111 and BCM-A031 are stored at the same time.
1 - Erasing diagnostic trouble code (DTC)
2 - DONE
-------------------------------------------------
Erasing diagnostic trouble code (DTC)
Erasing diagnostic trouble codes (DTCs)
Erasing diagnostic trouble codes (DTCs)
- Ignition on.
Erase diagnostic trouble codes (DTCs).
Continue - DONE
------------------------
DONE - DONE
-------------------------------------------------
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.