Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
The control modules in the car continually transmit and receive information over the data network (Controller Area Network). When the brake control module (BCM) is supplied with voltage the CAN controller which handles Controller Area Network communication is initialized.
Diagnostic trouble code (DTC) BCM-0151 is stored if initialization of the CAN controller fails.
The diagnostic trouble code (DTC) can be diagnosed while the ignition is switched on.
Substitute value
- Traction control is blocked
- Stability control is blocked
- Active yaw control is blocked
- All communication to and from the brake control module (BCM) is shut off.
Hint: For information about abbreviations, see Brake system, abbreviations Brake System, Abbreviations.
Possible source
- Internal fault in the brake control module (BCM).
Fault symptom[s]
- The anti-spin warning lamp is lit (up to and including 2002 model year)
- General yellow warning lamp lit (from model year 2003 inclusive)
- The stability control system does not function
- The traction control system does not function.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.