Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.4L VIN 64 B5244S6REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSBCM CODES (BRAKE CONTROL MODULE)BCM-0145TOO LONG STABILITY CONTROL
2004 Volvo V70 L5-2.4L VIN 64 B5244S6
Too Long Stability Control
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Too Long Stability Control
Too long stability control
Visually checking the brakes
Hint: The diagnostic trouble code (DTC) indicates that the stability function has been active for too long.
Check the front and rear brakes. Check there is no overheating damage to brake caliper, brake pads or brake disc. Replace damaged components.
Tell the customer why the anti-spin function was temporarily blocked and why the ABS warning lamp was lit.
Other information
- To remove or replace brake calipers, see Brake calipers front, replacing Removal and Replacement and Brake calipers rear, replacing Removal and Replacement
- To remove or replace brake pad, see Brake pads front, replacing Service and Repair and Brake pads rear, replacing Service and Repair
- To remove or replace brake disc, see Brake disc front, replacing Service and Repair and Brake discs rear, replacing Service and Repair.
Continue - DONE
-------------------------------------------------
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.