Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
Note! This diagnostic trouble code (DTC) applies only to vehicles with dynamic stability and traction control (DSTC).
The brake pressure sensors transmit signals to the brake control module (BCM) indicating the pressure in the brake system. If the control module registers an incorrect signal from any brake pressure sensor, then trouble code BCM-0130 or BCM-0133 is generated depending on sensor.
Note! When cables to the brake pressure sensors are physically interchanged when installing, troubleshoot both sensors when trouble code BCM-0130 or BCM-0133 is detected.
Substitute value
- Traction control is blocked.
- SC is blocked.
- Active yaw control is blocked.
Hint: For more information about abbreviations, see: Brake system, abbreviations Brake System, Abbreviations
Possible source
- Open-circuit in the wiring.
- Wiring is short-circuited to ground or supply voltage.
- Damaged pressure sensor.
- Internal fault in the control module.
Fault symptom[s]
- Warning light anti-spin on (applies to model year -2002)
- General yellow warning light on (applies to model year 2003-)
- Anti-spin not working
- Stability function is not working
- Anti skid function is not working
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.