Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.4L VIN 64 B5244S6REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSBCM CODES (BRAKE CONTROL MODULE)BCM-0061DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo V70 L5-2.4L VIN 64 B5244S6
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
In cars with traction control (STC/DSTC/TRACS), the brake control module registers how much the brakes are used and then calculates the temperature of all brake discs. Diagnostic trouble code (DTC) BCM-0061 is stored if the calculated temperature exceeds 450°C.
The diagnostic trouble code (DTC) can be diagnosed while the ignition is switched on.
Substitute value
- Traction control is blocked.
Hint: For information about brake system abbreviations, see Brake system, abbreviations Brake System, Abbreviations.
Possible source
- Excessive anti-spin control
- Brakes applied too long (brakes have been used so much that brake disc temperature has become too high).
Note! This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.
Fault symptom[s]
- Anti-spin does not function.
Note! The anti-spin function is deactivated until the temperature of the brake discs is below 300°C.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.