Diagnostic Trouble Code (DTC) Information

2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Diagnostic Trouble Code (DTC) Information





Diagnostic trouble code (DTC) information AEM-6C52

Condition




The diagnostic trouble code (DTC) is stored if the control module registers that the signal is too low or there is an open-circuit in the signal cable for alarm output P1.
The diagnostic trouble code (DTC) can be diagnosed when the ignition is on and alarm output P1 is not activated.

Substitute value
- None.

Possible source
- Short-circuit to ground in the signal cable for alarm output P1
- Open-circuit in the signal cable for alarm output P1
- Damaged alarm.

Fault symptom[s]
- The alarm does not function at all.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.