Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004S80 L6-2.9L TURBO VIN 91 B6294TREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSTCM CODES (TRANSMISSION CONTROL MODULE)TCM-0117INTERMITTENT FAULTSIGNAL MISSING. INTERMITTENT FAULT
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294T
Signal Missing. Intermittent Fault
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294TSECTION Signal Missing. Intermittent Fault
Signal missing. Intermittent fault
Intermittent fault
Check the transmission control module (TCM) and transmission connectors. Check for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the cables between control module terminal #A52 (#A52) and transmission connector terminal #D3. Check the cables between control module terminal #B10 (#A70) and transmission connector terminal #D4. Check for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Hint: Check solenoid SLT. Measure the resistance between terminals #D3 and #D4 on transmission connector A. The resistance should be 5-6 ohms at 20°C.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box, B5254T2 Connecting the Test Box
- To disconnect the transmission control module (TCM), see Transmission control module (TCM), replacing, B5254T2, AW50/51 AWD, B5254T2, AW55-50/51SN Service and Repair
- To disconnect the transmission connectors, see Connectors transmission, disconnecting / connecting
- For information about signals, see Signal description. Transmission control module (TCM), AW55-50/51SN, AW50/51 AWD Signal Description. Transmission Control Module (TCM).
Select Continue when the fault has been remedied.
Continue - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Exit fault-tracing
------------------------
Attempt New Test - Intermittent fault
-------------------------------------------------
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.