Diagnostic Trouble Code (DTC) Information

2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294TSECTION Diagnostic Trouble Code (DTC) Information





Diagnostic trouble code (DTC) information

Condition




- Diagnostic trouble code (DTC) ECM-6400 (camshaft intake) or ECM-6410 (camshaft exhaust) is stored if the engine control module (ECM) registers that the signal from the camshaft reset valve is too low or missing.

Substitute value
- Shutting off the variable camshaft.

Possible source
- Contact resistance in the terminals
- Open-circuit in the signal cable
- Short-circuit to ground in the signal cable
- Short-circuit to supply voltage in the signal cable (open-circuit in the fuse)
- Open-circuit in the voltage supply cable
- Defective camshaft reset valve.

Fault symptom[s]
- Malfunction indicator lamp (MIL) lit
- The engine does not start (open-circuit in the fuse).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.