Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004S80 L6-2.9L TURBO VIN 91 B6294TREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSECM CODES (ENGINE CONTROL MODULE)ECM-5000DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294T
Diagnostic Trouble Code (DTC) Information
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294TSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
Diagnostic trouble code (DTC) ECM-5000 is stored if the engine control module (ECM) registers a fault in the signal cable from the air conditioning (A/C) pressure sensor.
Diagnostic trouble code (DTC) ECM-5000 is stored when the air conditioning (A/C) pressure is too low and it is registered by the engine control module (ECM) as a fault.
Substitute value
none
Possible source
Signal too high:
- short-circuit to supply voltage in the signal cable
- open-circuit in power supply
- open-circuit in ground lead
- defective air conditioning (A/C) pressure sensor
Signal too low:
- short-circuit to ground in the signal cable
- open-circuit in signal cable
- contact resistance in connectors
- defective air conditioning (A/C) pressure sensor
Signal missing:
- defective air conditioning (A/C) pressure sensor
- low pressure in the air conditioning (A/C) system
- leakage in the air conditioning (A/C) system
Fault symptom[s]
- Air conditioning (A/C) system does not work
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.