Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004S80 L6-2.9L TURBO VIN 91 B6294TREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSECM CODES (ENGINE CONTROL MODULE)ECM-4024DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294T
Diagnostic Trouble Code (DTC) Information
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294TSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
Diagnostic trouble code (DTC) ECM-4024 is stored if the control module registers that the signal from the leak diagnostic unit pump is too high, too low or missing.
Substitute value
The leak diagnostic is shut off.
Possible source
Signal too high:
- Short-circuit to supply voltage in the signal cable
- Defective pump.
Signal too low:
- Short-circuit to ground in the signal cable.
Signal missing:
- Contact resistance in the terminals
- Open-circuit in the signal cable
- Open-circuit in the power cable
- Defective pump.
Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.