Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004S80 L6-2.9L TURBO VIN 91 B6294TREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSECM CODES (ENGINE CONTROL MODULE)ECM-4007DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294T
Diagnostic Trouble Code (DTC) Information
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294TSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
When the control module activates evaporative emission system (EVAP) control, the idle air trim or short-term fuel trim will change. Diagnostic trouble code (DTC) ECM-4007 is stored if the engine control module (ECM) does not detect any change in the idle air trim or in the long term fuel trim when evaporative emission (EVAP) control is active. The engine control module (ECM) interprets this as a faulty evaporative emission (EVAP) system.
Substitute value
None.
Possible source
Open:
- Faulty EVAP canister purge valve.
Closed:
- Blocked hose between the EVAP canister and the EVAP canister purge valve
- Blocked hose between the EVAP canister purge valve and the intake manifold
- Faulty EVAP canister purge valve.
Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.