Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004S80 L6-2.9L TURBO VIN 91 B6294TREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSECM CODES (ENGINE CONTROL MODULE)ECM-3503DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294T
Diagnostic Trouble Code (DTC) Information
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294TSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
Diagnostic trouble code (DTC) ECM-3503 is stored at start up if the engine control module (ECM) detects misfiring during the first 1000 revs after engine start up.
Diagnostic trouble code (DTC) ECM-3503 emission effect or ECM-3503 three-way catalytic converter (TWC) damage is stored (depending on the seriousness of the misfire) if the engine control module (ECM) detects misfiring after the first 1000 revs after engine start up.
The diagnostic trouble code (DTC) is always stored together with a diagnostic trouble code (DTC) which indicates the cylinder which is misfiring (ECM-35X3).
Substitute value
- Three-way catalytic converter (TWC) diagnosis shut off
- Leakage diagnosis shut off
- Rear heated oxygen sensor control shut off
- Fuel trim switched off.
Possible source
- Low fuel level
- Repeated cold starting where the engine coolant temperature (ECT) has reached normal operating temperature between starts
- Water in the spark plug wells
- Defective spark plug
- Contaminated or incorrect fuel
- Poor fuel quality (summer fuel in winter).
- Blocked / leaking injector
- Air leakage
- Blocked crankcase ventilation.
- Damaged VVT-unit.
- Faulty fuel pressure
- Uneven compression
Fault symptom[s]
- The malfunction indicator lamp (MIL) flashes
- The engine misfires
- The engine is difficult to start
- Deterioration in performance
- Uneven idle
- The engine is not firing on all cylinders.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.