Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004S80 L6-2.9L TURBO VIN 91 B6294TREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSECM CODES (ENGINE CONTROL MODULE)ECM-2310SIGNAL TOO HIGH. INTERMITTENT FAULT
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294T
Signal Too High. Intermittent Fault
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294TSECTION Signal Too High. Intermittent Fault
Signal too high. Intermittent fault
Checking the wiring
Check the cable between injector terminal 2 and control module:
- terminal #A16 (#A16) (ECM 2310)
- terminal #A15 (#A15) (ECM 2320)
- terminal #A33(#A33) (ECM 2330)
- terminal #A32 (#A32) (ECM 2340)
- terminal #A34 (#A34) (ECM 2350)
- terminal #A14 (#A14) (ECM 2360).
Check for an intermittent short-circuit to supply voltage.
Other information
- To connect the breakout box / access the control module, see Connecting the breakout box, B5254T2 Connecting the Test Box
- To access or replace the injector, see Injectors/pulsation dampers, replacing Service and Repair
- For information about signals, see Signal specification Signal Specification
- Checking wiring and terminals Checking Wiring And Terminals.
Continue - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Exit fault-tracing
------------------------
Attempt New Test - Checking the wiring
-------------------------------------------------
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.