Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004S80 L6-2.9L TURBO VIN 91 B6294TREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSECM CODES (ENGINE CONTROL MODULE)ECM-1300DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294T
Diagnostic Trouble Code (DTC) Information
2004 Volvo S80 L6-2.9L Turbo VIN 91 B6294TSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information ECM-1300
Condition
If the signal from the mass air flow sensor deviates in relation to the calculated air mass, the diagnostic trouble code is generated in the engine control module (ECM). Calculated air mass is based on throttle position and engine speed.
Substitute value
- initial boost pressure
- rear heated oxygen sensor (HO2S) control shut off
- misfire diagnosis shut off
Possible source
Flow too high:
- short-circuit to supply voltage in the signal cable
- open-circuit in the ground lead
- defective sensor
Flow too low:
- air leakage
- contact resistance
- Contaminated throttle body (TB).
- short-circuit to ground in the signal cable
- open-circuit in signal cable
- open-circuit in power supply cable
- defective sensor
Fault symptom[s]
- poor performance
- Uneven idle
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.