Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Checking cables
- Ignition off.
- Remove the door panel from the relevant door according to Door panel
.
Check the circuit for the relevant door as follows:
For the left front and rear doors: check the cable between VGLA control module #A2 and the relevant gray lock unit connector terminal 4 for an open-circuit according to Open-circuit, permanent faults . For the right front and rear doors: check the cable between VGLA control module #A15 and the relevant gray lock unit connector terminal 1 for an open-circuit according to Open-circuit, permanent faults . Also check the gray lock unit connector for the relevant door for oxidation and contact resistance according to Contact resistance and oxidation .
Remedy as necessary. Select "Continue".
- Continue
Refer to Verification
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.