Electrical Component Locator: Grounds

2004 Volvo C70 2.4 63SECTION Grounds
GROUNDS LOCATION

Component Location
G31/1 At rear of right fender. See Figure.
G31/2 At rear of left fender. See Figure.
G31/3 At rear center of cargo compartment. See Figure.
G31/4 At rear left side of engine. See Figure.
G31/6 At left kick panel. See Figure.
G31/10 At right kick panel. See Figure.
G31/44 At left front of engine compartment. See Figure.
G31/46 At left rear of passenger's compartment, near floor. See Figure.
G31/47 At left rear of passenger's compartment, near floor. See Figure.
G31/48 At right rear of passenger's compartment, near floor. See Figure.
G31/53 Left side of engine compartment. See Figure.
G31/66 Below driver's seat, near rocker panel. See Figure.
G31/67 Below passenger's seat, near rocker panel. See Figure.
G31/70 Left front corner of engine compartment. See Figure.
G31/72 At left rear of passenger's compartment, near floor. See Figure.
G31/73 At right rear of passenger's compartment, near floor. See Figure.
G31/83 At left kick panel. See Figure.
G31/84 At right kick panel. See Figure.
G31/88 At top of engine, near spark plugs. See Figure.
G31/89 At top of engine, near spark plugs. See Figure.
G31/91 At left side of engine. See Figure.
G31/93 At rear of left fender. See Figure.
G31/94 At rear of right fender. See Figure.
G31/95 At rear of left fender. See Figure.
G31/96 At rear of right fender. See Figure.
G31/98 At front center of headliner. See Figure.
G31/99 Above left rear window. See Figure.
G31/102 Behind left corner of front bumper. See Figure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.