Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2013BEETLE BASE, 2D HATCHBACK, 2.5L ENG VIN X, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1680 (ENGINE CONTROLS - PINPOINT TEST NB: MALFUNCTION INDICATOR LAMP THROUGH PINPOINT TEST Z: INTERMITTENT - (EXCEPT DIESEL & HYBRID))
2013 Volkswagen Beetle Base, 2D Hatchback, 2.5L Eng VIN X, Standard Trans
Section 1680 (Engine Controls - Pinpoint Test NB: Malfunction Indicator Lamp Through Pinpoint Test Z: Intermittent - (Except Diesel & Hybrid))
2013 Volkswagen Beetle Base, 2D Hatchback, 2.5L Eng VIN X, Standard TransSECTION Section 1680 (Engine Controls - Pinpoint Test NB: Malfunction Indicator Lamp Through Pinpoint Test Z: Intermittent - (Except Diesel & Hybrid))
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2005 Mercury Sable, 2005 Mercury Mountaineer, 2005 Mercury Monterey, 2005 Mercury Montego, and 2005 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
- Pinpoint Test NB: Malfunction Indicator Lamp
- Pinpoint Test NC: Ignition Engine Speed Input Circuit
- Pinpoint Test ND: Engine RPM\Vehicle Speed Limiter Reached
- Pinpoint Test QA: Unable to Activate Self-Test/Network Communication Error
- Pinpoint Test QB: DTCs P0603 or P1633: Keep Alive Power
- Pinpoint Test QC: DTC P1000: On-Board Diagnostic (OBD) Systems Readiness Test Not Complete
- Pinpoint Test QD: DTC P1260: Passive Anti-Theft System
- Pinpoint Test QE: Electronic Throttle Control (ETC) System
- Pinpoint Test TA: Clutch Pedal Position (CPP) Switch
- Pinpoint Test TB: Transmission Control Switch (TCS)/ Transmission Control Indicator Lamp (TCIL)
- Pinpoint Test TG: 4x4 Low Switch (4X4LSW) And Four Wheel Drive (4WD) Switch
- Pinpoint Test TJ: Output Shaft Speed (OSS) Sensor
- Pinpoint Test Z: Intermittent
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.