Front A/C Display Control Head -E87- / CLIMATRONIC Control Module -J255

2012 Volkswagen Jetta TDI, 4D Sedan, Standard TransSECTION Front A/C Display Control Head -E87- / CLIMATRONIC Control Module -J255
WARNING: This page is about a different variant/trim than selected.
NOTE:

The Climatronic control module and the Front A/C display control head are a single unit and cannot be disassembled.

Removing 

-- Remove the trim in the center of the instrument panel. Refer to Removal and Installation .

Fig 1: Identifying A/C Control Head E87 Remove/Install Components
GWWM87-0122Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -2- and the Front A/C display control head -1-.

-- Disconnect the connectors from the Front A/C display control head.

Installing 

Install in reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.