Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2002PASSAT GLX 4MOTION, 4D SEDANREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSBODY EXTERIOR50 BODY, FRONTFENDERFRONT FENDER, REMOVING AND INSTALLING 10.00INSTALLING
2002 Volkswagen Passat GLX 4Motion, 4D Sedan
Front fender, removing and installing 10.00: Installing
2002 Volkswagen Passat GLX 4Motion, 4D SedanSECTION Installing
- Before bolting on fender, insert one zinc intermediate piece AKL 381 035 50 each for bolt points in contact area.
- Make sure gaps are parallel and gap dimensions: Body panel gaps; Body, front
Rest of installation of front fender is reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.