SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2002GOLF GL, 2D HATCHBACK, 2.0 K, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSEATSBODY ON BOARD DIAGNOSTIC (OBD) (A4 PLATFORM) [CONVENIENCE SYSTEM (VEHICLES WITH POWER WINDOWS), ON BOARD DIAGNOSTIC (OBD)]01 ON BOARD DIAGNOSTIC (OBD)CONVENIENCE SYSTEM (VEHICLES WITH POWER WINDOWS), ON BOARD DIAGNOSTIC (OBD)DISPLAY GROUP OVERVIEW, VEHICLES THROUGH 05.01EVALUATING DISPLAY GROUP NUMBER 009
2002 Volkswagen Golf GL, 2D Hatchback, 2.0 K, Standard

Evaluating display group number 009

2002 Volkswagen Golf GL, 2D Hatchback, 2.0 K, StandardSECTION Evaluating display group number 009
Display zone  Description  Display  Corrective action 
1 Instrument illumination mv = 0 to 100%
(in 16 steps)
  • Visual check of wiring
  • Check that connections of relevant current circuit are correctly connected and seated securely while simultaneously observing display
  • If the display does not change when operating, repair malfunction or replace relevant component
  • Erase DTC memory
  • Perform functional check
  • Check DTC memory again
2 Speed signal mv = km/h
(steps: 2km/h)		  
3 Remote control key button unlock, lock,
RLR1), Panic2)
(with 0 or 1)
  • If necessary adapt radio wave remote control (Function 10, adaptation. Refer to Adaptation  )
4 Interior monitor sensor yes
no
not installed		  

1) Only vehicles for USA, RLR= Rear lid remote release

2) Only vehicles for USA, alarm system and turn signal lights are activated

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.