Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2002GOLF GL, 2D HATCHBACK, 2.0 K, STANDARDREPAIR AND DIAGNOSISRESTRAINTSSEAT BELTSBODY ON BOARD DIAGNOSTIC (OBD) (A4 PLATFORM) [CONVENIENCE SYSTEM (VEHICLES WITH POWER WINDOWS), ON BOARD DIAGNOSTIC (OBD)]01 ON BOARD DIAGNOSTIC (OBD)CONVENIENCE SYSTEM (VEHICLES WITH POWER WINDOWS), ON BOARD DIAGNOSTIC (OBD)ADAPTATION
2002 Volkswagen Golf GL, 2D Hatchback, 2.0 K, Standard
Convenience System (Vehicles With Power Windows), On Board Diagnostic (OBD): Adaptation
2002 Volkswagen Golf GL, 2D Hatchback, 2.0 K, StandardSECTION Adaptation
Ignition keys, matching to radio wave remote control
NOTE:
- If new or additional ignition keys are required they must be matched to the immobilizer and convenience system control electronics.
- The matching procedure must always be carried out for all the ignition keys, including the existing ones.
- The number of keys already matched will be displayed when the adaptation (matching) function is selected.
- With the introduction of this generation of convenience system it is possible to program additional functions. The functions and the programming are described. Refer to Radio wave remote control function variations, vehicles through 05.98 .
- The matching can be interrupted with the "C" button of the V.A.G 1551.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.