Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2020RAV4 XLE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 36 (ENGINE CONTROL SYSTEM (A25A-FKS) - DIAGNOSTIC CODES (6 OF 9))SFI SYSTEMDTC P0606-09: CONTROL MODULE PROCESSOR (BRAKE OVERRIDE SYSTEM OUTPUT SIGNAL) COMPONENT FAILURE [12/2021 - ]TYPICAL ENABLING CONDITIONS
2020 Toyota RAV4 XLE, AWD
Typical Enabling Conditions
2020 Toyota RAV4 XLE, AWDSECTION Typical Enabling Conditions
WARNING: This page is about a different car, the 2025 Toyota RAV4, 2024 Toyota RAV4, 2023 Toyota RAV4, 2022 Toyota RAV4, and 2021 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
| Monitor runs whenever the following DTCs are not stored | None |
| All of the following conditions are met | - |
| Accelerator opening angle | 56.542° or more |
| STP signal | ON |
| Vehicle speed | 40 km/h (25 mph) or more |
| Accelerator opening angle value | No malfunction |
| STP | No malfunction |
| Wheel speed | No malfunction |
| Ignition switch | ON |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.