Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2020RAV4 XLE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 36 (ENGINE CONTROL SYSTEM (A25A-FKS) - DIAGNOSTIC CODES (6 OF 9))
2020 Toyota RAV4 XLE, AWD
Section 36 (Engine Control System (A25A-FKS) - Diagnostic Codes (6 Of 9))
2020 Toyota RAV4 XLE, AWDSECTION Section 36 (Engine Control System (A25A-FKS) - Diagnostic Codes (6 Of 9))
WARNING: This page is about a different car, the 2025 Toyota RAV4, 2024 Toyota RAV4, 2023 Toyota RAV4, 2022 Toyota RAV4, and 2021 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- SFI System
- DTC P050A-00: Cold Start Idle Control System Performance [08/2020 - 11/2024]
- DTC P050A-00: Cold Start Idle Control System Performance [11/2024 - ]
- DTC P050B-00: Cold Start Ignition Timing Performance [08/2020 - ]
- DTC P0520-12: Engine Oil Pressure Sensor/Switch "A" Circuit Short to Battery; DTC P0520-14: Engine Oil Pressure Sensor/Switch "A" Circuit Short to Ground or Open [08/2020 - ]
- DTC P0520-24: Engine Oil Pressure Sensor/Switch "A" Signal Stuck High; DTC P0520-2A: Engine Oil Pressure Sensor/Switch "A" Signal Stuck in Range [08/2020 - 12/2021]
- DTC P0520-24: Engine Oil Pressure Sensor/Switch "A" Signal Stuck High; DTC P0520-2A: Engine Oil Pressure Sensor/Switch "A" Signal Stuck in Range [12/2021 - ]
- DTC P0524-77: Engine Oil Pressure Too Low (Severe); DTC P15F0-09: Engine Oil Pressure Too Low (Moderate); DTC P15F0-77: Engine Oil Pressure Too Low (Minor); DTC P15F1-09: Variable Oil Pump Component Failure; DTC P15F1-77: Variable Oil Pump Commanded Position Not Reachable [08/2020 - ]
- DTC P0560-14: System Voltage Circuit Short to Ground or Open [08/2020 - ]
- DTC P0597-12: Thermostat Heater Control Circuit Short to Battery [08/2020 - ]
- DTC P0597-14: Thermostat Heater Control Circuit Short to Ground or Open [08/2020 - ]
- DTC P059A-71: Active Grille Air Shutter "A" Actuator Stuck; DTC P059A-79: Active Grille Air Shutter "A" Mechanical Linkage Failure [12/2021 - ]
- DTC P059F-73: Active Grille Air Shutter "A" Actuator Stuck Closed; DTC P05A0-72: Active Grille Air Shutter "A" Actuator Stuck Open [08/2020 - 12/2021]
- DTC P05A0-74: Active Grille Air Shutter "A" Actuator Slipping [08/2020 - 12/2021]
- DTC P05A2-11: Active Grille Air Shutter "A" Circuit Short to Ground; DTC P05A2-12: Active Grille Air Shutter "A" Circuit Short to Battery; DTC P05A2-13: Active Grille Air Shutter "A" Circuit Open [08/2020 - 12/2021]
- DTC P05A2-12: Active Grille Air Shutter "A" Circuit Short to Battery [12/2021 - ]
- DTC P05A2-7E: Active Grille Air Shutter "A" Actuator Stuck On; DTC P05A2-7F: Active Grille Air Shutter "A" Actuator Stuck Off [08/2020 - 12/2021]
- DTC P05B1-12: Active Grille Air Shutter "B" Circuit Short to Battery; DTC P05B1-14: Active Grille Air Shutter "B" Circuit Short to Ground or Open; DTC P05B1-31: Active Grille Air Shutter "B" No Signal [08/2020 - 12/2021]
- DTC P0604-44: Internal Control Module Random Access Memory (RAM) Error Data Memory Failure [08/2020 - ]
- DTC P0606-09: Control Module Processor (Brake Override System Output Signal) Component Failure [12/2021 - ]
- DTC P0606-47: Control Module Processor Watchdog/Safety MCU Failure [08/2020 - ]
- DTC P0606-94: Control Module Processor Unexpected Operation [12/2021 - ]
- DTC P0607-47: Control Module Performance Bank 1 Watchdog/Safety MCU Failure; DTC P0607-87: Control Module Performance Bank 1 Missing Message [08/2020 - ]
- DTC P060D-49: Internal Control Module Accelerator Pedal Position Performance Internal Electronic Failure [08/2020 - ]
- DTC P060E-49: Internal Control Module Throttle Position Performance Internal Electronic Failure [08/2020 - ]
- DTC P0613-47: TCM Processor Watchdog/Safety MCU Failure [08/2020 - ]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.