Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA20064RUNNER SR5, 4.7 T, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTNAVIGATION SYSTEM - DIAGNOSTICSDTC 44-43 DVD-ROM ABNORMALINSPECTION PROCEDURE
2006 Toyota 4Runner SR5, 4.7 T, AWD
Inspection Procedure
2006 Toyota 4Runner SR5, 4.7 T, AWDSECTION Inspection Procedure
HINT:
After the inspection is completed, clear the DTCs.
- CHECK IF A PROPER DVD IS INSERTED
- Make sure that the DVD is a video DVD or a CD with an MP3 file, and that it is not deformed, flawed, stained, burred, or otherwise defective.
OK: Normal DVD or CD
HINT:
- Translucent or uniquely-shaped DVDs or CDs cannot be played.
- For details on playable DVDs or CDs, refer to the Owner's Manual.
NG: DISC IS FAULTY
OK: GO TO NEXT STEP.
- Make sure that the DVD is a video DVD or a CD with an MP3 file, and that it is not deformed, flawed, stained, burred, or otherwise defective.
- CHANGE DISC
- Replace the disc with another and recheck.
- Replace the disc with another normal one.
- Clear the DTCs (See DTC CHECK/CLEAR ).
- Recheck for DTCs and check if the same trouble occurs again.
OK: Malfunction disappears.
NG: REPLACE TELEVISION DISPLAY ASSEMBLY
OK: END
- Replace the disc with another and recheck.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.