SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 963 (OVERHAUL - AUTOMATIC TRANSMISSION)SHIFT INTERLOCK CABLEINSTALLATION
2004 Toyota Matrix XR, FWD, Standard

Shift Interlock Cable: Installation

2004 Toyota Matrix XR, FWD, StandardSECTION Installation
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that ignition key is in ACC position (Fig 1).
    Fig 1: Identifying Ignition Key/Switch Positions
    G03574338Courtesy of DAIMLERCHRYSLER CORP.
  2. Install shift interlock cable to ignition cylinder (Fig 2). Secure cable to instrument panel at retainer.
    Fig 2: Installing BTSI Cable At Ignition Cylinder
    G03574339Courtesy of DAIMLERCHRYSLER CORP.
  3. Connect shift interlock cable connector (Fig 2).
  4. Route shift interlock cable towards shift mechanism.
  5. Connect interlock cable core to shift mechanism cam, and then secure cable housing to shift mechanism (Fig 3).
    Fig 3: Installing BTSI Cable At Mechanism
    G03574340Courtesy of DAIMLERCHRYSLER CORP.
  6. Adjust interlock cable. (Refer to ADJUSTMENTS )
  7. Install center console assembly (Fig 4).
    Fig 4: Removing Front Floor Console
    G03574341Courtesy of DAIMLERCHRYSLER CORP.
  8. Install PRNDL surround bezel (Fig 5).
    Fig 5: PRNDL Surround Bezel Removal/ Installation
    G03574342Courtesy of DAIMLERCHRYSLER CORP.
  9. Install gearshift bezel (Fig 6).
    Fig 6: Installing Gearshift Bezel
    G03574343Courtesy of DAIMLERCHRYSLER CORP.
  10. Install gearshift knob (Fig 7). Torque set-screw to 2 N.m (20 in. lbs.).
    Fig 7: Installing Gearshift Knob
    G03574344Courtesy of DAIMLERCHRYSLER CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.