SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 963 (OVERHAUL - AUTOMATIC TRANSMISSION)SHIFT INTERLOCK CABLEADJUSTMENTSADJUSTMENT - INTERLOCK CABLE
2004 Toyota Matrix XR, FWD, Standard

Adjustment - Interlock Cable

2004 Toyota Matrix XR, FWD, StandardSECTION Adjustment - Interlock Cable
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the gearshift knob (Fig 1).
  2. Remove the gearshift bezel (Fig 2).
  3. Remove PRNDL surround bezel (Fig 3).
  4. Move the gear shifter to PARK and the ignition key to the LOCK position (Fig 4).
  5. If the interlock cable is being replaced, remove the pin to allow cable to "self adjust." Press locking clip (Fig 5) by hand to secure adjustment.
  6. If the interlock cable is not being replaced, the pin will not exist. Loosen the locking clip (Fig 5) on the interlock cable to allow cable to "self adjust." Press locking clip (Fig 5) by hand to secure adjustment.
    Fig 1: Removing Gearshift Knob
    G03574345Courtesy of DAIMLERCHRYSLER CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.