SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 918 (AUDIO & VISUAL SYSTEM)RADIO RECEIVER ASSYREPLACEMENT
2004 Toyota Matrix XR, FWD, Standard

Radio Receiver ASSY: Replacement

2004 Toyota Matrix XR, FWD, StandardSECTION Replacement
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

  • COMPONENTS 
  • Installation is in the reverse order of removal.
  1. REMOVE SHIFT LEVER KNOB SUB-ASSY (SEE  REPLACEMENT  ) 
  2. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSY (SEE  REPLACEMENT  ) 
  3. REMOVE CONSOLE PANEL SUB-ASSY UPPER (SEE  REPLACEMENT  ) 
  4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSY CENTER (SEE  REPLACEMENT  ) 
  5. REMOVE CENTER CLUSTER INTEGRATION PANEL ASSY 
    1. Remove the 4 bolts.
    2. Disconnect the connector.
    3. Disengage the 4 claws and remove the center cluster integration panel assy.
      Fig 1: Removing Center Cluster Integration Panel Assy
      G03553249Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE RADIO BRACKET NO.1 
    1. Remove the 6 screws and radio bracket No.1.
      Fig 2: Removing Radio Bracket No. 1
      G03553250Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE RADIO BRACKET NO.2 
    1. Remove the 5 screws and radio bracket No.2.
      Fig 3: Removing Radio Bracket No. 2
      G03553251Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE RADIO RECEIVER ASSY 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.