SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 838 (REAR RIGHT SEAT CONTROL SYSTEM - DIAGNOSIS)CIRCUIT INSPECTIONPOWER SOURCE CIRCUITINSPECTION PROCEDURE
2004 Toyota Matrix XR, FWD, Standard

Inspection Procedure

2004 Toyota Matrix XR, FWD, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check RR SEAT RH and MPX-B1 fuse. 

    CHECK: 

    Check continuity of RR SEAT RH and MPX-B1 fuse.

    OK: 

    Continuity 

    1. NG : Replace the failure fuse. 
    2. OK : Go to next step. 
  2. Check voltage between terminals +B, SYSB and GND of rear RH seat ECU connector. 

    PREPARATION: 

    1. Turn the ignition switch OFF.
    2. Disconnect the rear RH seat ECU connector.

    CHECK: 

    Measure voltage between terminals +B, SYSB and GND.

    OK: 

    Voltage: 10 - 14 V 

    1. OK : Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ). 
    2. NG : Go to next step. 
  3. Check harness and connector between rear RH seat ECU and body ground (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
    1. OK : Repair or replace harness or connector. 
    2. NG : Proceed to next circuit inspection shown on problem symptom table (See  PROBLEM SYMPTOMS TABLE  ). 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.