Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 60 (DIAGNOSIS - A650E)COMPONENT LOCATIONS
2004 Toyota Matrix XR, FWD, Standard
Component Locations
2004 Toyota Matrix XR, FWD, StandardSECTION Component Locations
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus LS 430, 2002 Lexus IS 300, 2002 Lexus GS 430, and 2002 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.
For additional information, see Figure-Figure .
| Component | Location |
|---|---|
| DLC3 | Under Left Side Of Instrument Panel |
| ECM | Left Side Of Engine Compartment |
| E-Shift Main Switch (GS 300 & IS 300) | In Console Near Gearshift Lever |
| O/D Direct Clutch Speed Sensor | Mounted On Left Front Of Transmission |
| PNP Switch | Mounted On Transmission |
| Pattern Select Switch | In Console Near Gearshift Lever |
| Stoplight Switch | Mounted On Brake Pedal Support Bracket |
| SNOW Indicator Light | In Instrument Panel |
| Transmission Control Switch | In Center Console |
| Vehicle Speed Sensor | On Extension Housing |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.