Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 564 (Power Steering Fluid): Bleeding
- CHECK FLUID LEVEL (See INSPECTION )
- JACK UP FRONT OF VEHICLE AND SUPPORT IT WITH STANDS
- TURN STEERING WHEEL
With the engine stopped, turn the wheel slowly from lock to lock several times.
- LOWER VEHICLE
- START ENGINE
Run the engine at idle for a few minutes.
- TURN STEERING WHEEL
- With the engine idling, turn the wheel to the left or the right full lock position and keep it there for 2-3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2-3 seconds.
- Repeat (a) several times.
- STOP ENGINE
- CHECK FOR FOAMING OR EMULSIFICATION
If the system has to be bled twice specifically because of foaming or emulsification, check for fluid leaks in the system.
- CHECK FLUID LEVEL (See INSPECTION )
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.