Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 364 (AIR BAG RESTRAINT SYSTEMS)DISPOSAL PROCEDURESOFF-VEHICLE DEPLOYMENTDRIVER-SIDE AIR BAG MODULE
2004 Toyota Matrix XR, FWD, Standard
Driver-side AIR Bag Module
2004 Toyota Matrix XR, FWD, StandardSECTION Driver-side AIR Bag Module
WARNING: This page is about a different car, the 2004 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Test Deployment Tool (09082-00700). See TESTING DEPLOYMENT TOOL . Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE under REMOVAL & INSTALLATION.
- Install 2 bolts (6 mm X 35 mm) with washers into holes located in rear of driver-side air bag module. Tighten bolts by hand. DO NOT overtighten bolts. Wrap strong wire at least twice around each bolt. See Fig 1. Ensure no slack is present in wire. If slack is present, or wire is not strong enough, driver-side air bag module may become loose due to shock when air bag is deployed.
- Position driver-side air bag module on rim of a scrap wheel and tire assembly with pad side facing upward. See Fig 2. Securely tie driver-side air bag module to wheel rim through lug nut holes. Place a large cardboard box (weighted at sides) or 3 scrap tires on top of driver-side air bag module.
- Connect Deployment Tools (09082-00700 and 09082-00802) to driver-side air bag module connector. Position deployment tool at least 33 feet (10 m) away from driver-side air bag module. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal. Press activation switch to deploy driver-side air bag module. Because of heat, wait 30 minutes before handling driver-side air bag module. Seal deployed air bag module in vinyl bag and dispose of in usual manner.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.