Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 364 (AIR BAG RESTRAINT SYSTEMS)DISABLING & ACTIVATING AIR BAG SYSTEMDISABLING SYSTEMFOR DIAGNOSTICS
2004 Toyota Matrix XR, FWD, Standard
For Diagnostics
2004 Toyota Matrix XR, FWD, StandardSECTION For Diagnostics
WARNING: This page is about a different car, the 2004 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch to LOCK position. Disconnect and shield negative battery cable. Wait at least 90 seconds. Disconnect air bag sensor assembly connectors. See AIR BAG SENSOR ASSEMBLY under REMOVAL & INSTALLATION. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE under REMOVAL & INSTALLATION. Disconnect passenger-side air bag module connector, accessible by removal of glove box assembly. See Fig 1.
- Disconnect right and left side air bag module connectors. See SIDE AIR BAG MODULE under REMOVAL & INSTALLATION. Disconnect right and left side curtain air bag module connectors. See SIDE CURTAIN AIR BAG MODULE under REMOVAL & INSTALLATION. Disconnect right and left front seat belt pretensioner connectors. See SEAT BELT PRETENSIONER under REMOVAL & INSTALLATION.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.