Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 226 (ANTI-LOCK BRAKE SYSTEM)SYSTEM TESTSTEST D: TS TERMINALCIRCUIT DESCRIPTION
2004 Toyota Matrix XR, FWD, Standard
Circuit Description
2004 Toyota Matrix XR, FWD, StandardSECTION Circuit Description
WARNING: This page is about a different car, the 2003 Toyota Tundra, 2002 Toyota Tundra, and 2001 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
Sensor check circuit detects abnormalities in speed sensor signal which cannot be detected when checking for DTCs. Connecting terminals Ts and CG of DLC3 in engine compartment starts sensor circuit check.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.