Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 129 (ENGINE CONTROL SYSTEM SELF DIAGNOSTICS)SELF-DIAGNOSTIC SYSTEMRETRIEVING DIAGNOSTIC TROUBLE CODESCHECK MODE DIAGNOSTIC TROUBLE CODE RETRIEVAL (HAND-HELD TESTER ONLY)
2004 Toyota Matrix XR, FWD, Standard
CHECK Mode Diagnostic Trouble Code Retrieval (Hand-Held Tester Only)
2004 Toyota Matrix XR, FWD, StandardSECTION CHECK Mode Diagnostic Trouble Code Retrieval (Hand-Held Tester Only)
WARNING: This page is about a different car, the 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If using Toyota hand-held tester, if ignition switch is turned from ON to ACC or OFF position during CHECK mode, all DTCs and freeze frame data will be erased from Engine Control Module (ECM). DO NOT switch from CHECK MODE to NORMAL mode until all DTCs and freeze frame data are recorded.
- Ensure vehicle battery is fully charged. Apply parking brake. Place transmission in Park or Neutral. Ensure A/C and ignition are off. Check that throttle valve is fully closed. Connect hand-held tester to Data Link Connector (DLC3) at driver's side of instrument panel. See Figure. Turn ignition on and then turn hand-held tester on.
- Switch hand-held tester from NORMAL mode to CHECK mode. Ensure Malfunction Indicator Light (MIL) on instrument cluster flashes to indicate CHECK mode operation. Start engine. If no DTCs are present, MIL will turn off. Try to simulate conditions of driveability complaint described by customer.
- Record any DTCs and freeze frame data displayed for system diagnosis. If driveability problem exists and no DTCs are present, go to TROUBLESHOOTING - NO CODES article for diagnosis by symptom.
- If any DTCs are present, perform appropriate DTC test under DIAGNOSTIC TESTS . For DTC description, see DIAGNOSTIC TROUBLE CODE DEFINITIONS under DIAGNOSTIC TROUBLE CODE DEFINITIONS. For more information on freeze frame data, see FREEZE FRAME DATA . For information on two-trip detection logic DTCs, see TWO-TRIP DETECTION LOGIC .
- After repairs for DTC have been completed, DTC must be cleared from ECM. See CLEARING DIAGNOSTIC TROUBLE CODES . Road test vehicle to ensure all symptoms and/or complaints have been repaired.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.