Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 143 (ANTI-LOCK)TORQUE SPECIFICATIONS
2004 Toyota Celica GT, Standard
Torque Specifications
2004 Toyota Celica GT, StandardSECTION Torque Specifications
WARNING: This page is about a different car, the 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft.Lbs. (N.m) |
|---|---|
| Front Speed Sensor Harness Clamp Bolt | 21 (29) |
| Rear Speed Sensor To Axle Carrier 4WD | 14 (20) |
| Wheel Lug Nuts | 76 (103) |
| INCH Lbs. (N.m) | |
| Bleeder Plugs | 74 (8.3) |
| Front Speed Sensor Bolt To Steering Knuckle | 71 (8) |
| Rear Speed Sensor To Axle Carrier 2WD | 71 (8) |
| Rear Speed Sensor Wire Harness | 48 (5) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.