Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2000RAV4 2-DOOR 2WD L4-2.0L (3S-FE)REPAIR AND DIAGNOSISCRUISE CONTROLTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSCONTROL SWITCH CIRCUIT (CRUISE CONTROL SWITCH)
2000 Toyota RAV4 2-Door 2WD L4-2.0L (3S-FE)
Control Switch Circuit (Cruise Control Switch)
2000 Toyota RAV4 2-Door 2WD L4-2.0L (3S-FE)SECTION Control Switch Circuit (Cruise Control Switch)
CIRCUIT DESCRIPTION
This circuit carries the SET/COAST RESUME/ACCEL and CANCEL signals (each voltage) to the ECU WIRING DIAGRAM
INSPECTION PROCEDURE
This circuit carries the SET/COAST RESUME/ACCEL and CANCEL signals (each voltage) to the ECU WIRING DIAGRAM
Wiring Diagram:
Steps 1 - 2:
Step 3:
Steps 4 - 6:
INSPECTION PROCEDURE
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.