Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 63 (WIRING SYSTEMS)
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Section 63 (Wiring Systems)
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Section 63 (Wiring Systems)
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
- Precautions
- General Description
- Connector Layout Diagram
- Connector Layout Diagram
- Engine Compartment
- Instrument Panel
- Door, Roof
- Floor
- L: Floor Harness, Coupling Harness, Seat Sensor (R) Wire, Seat Sensor (L) Wire/Q: Side Curtain-Air Bag Wire, Side-Air Bag (Driver Side) Harness, Side-Air Bag (Passenger Side) Harness/R: Fuel Pump Wire (Hatchback Model)
- L: Floor Harness, Seat Sensor (R) Wire, Seat Sensor (L) Wire/M: Trunk Room Harness/Q: Side-Air Bag (Driver Side) Harness, Side-Air Bag (Passenger Side) Harness/R: Fuel Pump Wire (Sedan Model)
- Rear
- Ground Point
- Power Supply Diagram
- System Circuit Diagram
- System Circuit Diagram
- A-1 Cranking System Circuit Diagram
- A-2 Charging System Circuit Diagram
- A-3 Ignition System Circuit Diagram
- A-4 Cooling System Circuit Diagram
- A-5 Engine and A/C Control System Circuit Diagram
- A-6 CVT Control System Circuit Diagram
- A-7 Immobilizer System Circuit Diagram
- A-8 Body Control System Circuit Diagram
- A-9 CAN Circuit Diagram
- A-10 4WD Control System
- B-1 Windshield Wiper and Washer Circuit Diagram
- B-2 Rear Wiper and Washer Circuit Diagram (Hatchback)
- B-3 Rear Defogger Circuit Diagram (Hatchback)
- B-3 Rear Defogger Circuit Diagram (Sedan)
- B-4 Power Window Circuit Diagram
- B-5 Power Door Lock Circuit Diagram
- B-6 Power Mirror Circuit Diagram (Hatchback)
- B-6 Power Mirror Circuit Diagram (Sedan)
- B-7 Horn Circuit Diagram
- B-8 Seat Heater Circuit Diagram
- B-9 Keyless Start System Circuit Diagram
- C-1 Combination Meter Circuit Diagram
- D-1 Head light System Circuit Diagram
- D-2 Position, Tail and Licence Plate Light System Circuit Diagram (Hatchback)
- D-2 Position, Tail and Licence Plate Light System Circuit Diagram (Sedan)
- D-3 Front Fog Light System Circuit Diagram
- D-4 Illumination Light System Circuit Diagram
- D-5 Interior Light System Circuit Diagram (Hatchback)
- D-5 Interior Light System Circuit Diagram (Sedan)
- D-6 Turn Signal and Hazard Warning Light System Circuit Diagram (Hatchback)
- D-6 Turn Signal and Hazard Warning Light System Circuit Diagram (Sedan)
- D-7 Brake Light System Circuit Diagram (Hatchback)
- D-7 Brake Light System Circuit Diagram (Sedan)
- D-8 Back-Up Light System Circuit Diagram (Hatchback)
- D-8 Back-Up Light System Circuit Diagram (Sedan)
- E-1 Heater System Circuit Diagram
- E-2 Auto A/C System Circuit Diagram
- F-1 Air Bag System Circuit Diagram (4ch)
- F-1 Air Bag System Circuit Diagram (10ch)
- F-1 Air Bag System Circuit Diagram (12ch)
- F-2 Anti-Lock Brake System Circuit Diagram
- F-3 Electronic Stability Program System Circuit Diagram
- F-4 Power Steering System Circuit Diagram (Mexico Model)
- G-1 Audio System Circuit Diagram
- G-2 Accessory Socket System Circuit Diagram
- List of Connectors
- Reassembling Note for Wiring Harness
- Specifications
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.