Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 60 (ELECTRONIC STABILITY PROGRAM)REPAIR INSTRUCTIONSSTEERING ANGLE SENSOR ON-VEHICLE INSPECTION
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Steering Angle Sensor On-Vehicle Inspection
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Steering Angle Sensor On-Vehicle Inspection
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Before each inspection, confirm steering angle sensor calibration is completed.
If calibration is incompleted, calibrate sensor referring to SENSOR CALIBRATION OF ESP® .
If calibration is incompleted, calibrate sensor referring to SENSOR CALIBRATION OF ESP® .
- Connect SUZUKI scan tool to DLC (1) with ignition switch OFF.
Special Tool
(A): SUZUKI scan tool (SUZUKI-SDT)
- Turn ignition switch to ON position and select menu "Data List" mode of SUZUKI scan tool. Refer to scan tool operators manual for further details.
- Check "Steering angle Sen" under "Data List" of SUZUKI scan tool in the following steering wheel conditions.
- Front wheels in straight-ahead position
- Rotate steering wheel a round in clockwise (counter clockwise) from straight-ahead position
If steering angle condition is out of specification, replace steering angle sensor.
Steering angle Specification
STEERING ANGLE SPECIFICATIONVehicle condition Steering angle Front wheels in straight-ahead position 0 ± 3° Rotate steering wheel a round in clockwise 360 ± 3° Rotate steering wheel a round in counterclockwise -360 ± 3°
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.