Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 60 (ELECTRONIC STABILITY PROGRAM)DIAGNOSTIC INFORMATION AND PROCEDURESESP® WARNING LIGHT CHECK
2013 Suzuki SX4 Crossover, Automatic CVT Trans
ESP® Warning Light Check
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION ESP® Warning Light Check
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch ON.
- Check that ESP® warning light (1) comes ON for about 2 seconds and then goes off.
If any faulty condition is found, advance to ESP® WARNING LIGHT DOES NOT COME ON AT IGNITION SWITCH ON or ESP® WARNING LIGHT COMES ON STEADY .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.