Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 60 (ELECTRONIC STABILITY PROGRAM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC C1040: ESP® FUNCTION FAILUREDTC TROUBLESHOOTING
2013 Suzuki SX4 Crossover, Automatic CVT Trans
DTC Troubleshooting
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION DTC Troubleshooting
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
C1040: SYMPTOM TROUBLESHOOTING REFERENCE CHART
| Step | Action | YES | NO |
|---|---|---|---|
| 1 | Was "Electronic Stability Program Check" performed | Go to Step 2. | Go to ELECTRONIC STABILITY PROGRAM CHECK . |
| 2 | Check DTC for ESP®
Is there any DTC(s) other than C1040? |
Go to applicable DTC troubleshooting. | Substitute a known-good ESP® hydraulic unit/control module assembly and recheck. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.