Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 44 (EXTERIOR TRIM)REPAIR INSTRUCTIONSLIFTGATE CENTER APPLIQUE REPLACEMENT
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Liftgate Center Applique Replacement
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Liftgate Center Applique Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
LIFTGATE CENTER REFERENCE TABLE
| Callout | Component Name |
|---|---|
Preliminary Procedure
|
|
| 1 | Liftgate Center Applique Nuts (Qty: 4) Tip: Release the four lower nuts, first and ensure the foam gaskets are in place on the studs prior to re-assembly. |
| 2 | Integral Retainers (Qty: 5) Tip: Release the five upper retainers, second. |
| 3 | Liftgate Center Applique Tip: Pull the panel rearward and disconnect the electrical connector and two bulbs from the liftgate panel. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.