SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (WIPERS/WASHERS)REPAIR INSTRUCTIONSREAR WINDOW WIPER ARM REPLACEMENT
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Rear Window Wiper Arm Replacement

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Rear Window Wiper Arm Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Rear Wiper Arm Nut Finish Cap & Windshield Wiper Assembly
G04845205Courtesy of SUZUKI OF AMERICA CORP.
REAR WINDOW WIPER ARM TABLE

Callout Component Name
1 Rear Wiper Arm Nut Finish Cap
2 Rear Wiper Arm Nut
CAUTION: Refer to FASTENER NOTICE .

Tightening torque 
28 N.m (21 lb ft) 
Tip:  Hold the blade tip on the first defroster grid line while torquing the wiper arm nut.
3 Windshield Washer Arm Assembly
  • Position wiper blade assembly above the blackout strip as shown in Fig 1.
  • Position the blade element on the first defroster grid line, above the blackout.
  • Operate the windshield wipers and inspect for proper operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.