SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (AUTOMATIC TRANSMISSION)REPAIR INSTRUCTIONSTHIRD GEAR BAND APPLY TUBE INSTALLATION
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Third Gear Band Apply Tube Installation

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Third Gear Band Apply Tube Installation
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Third Gear Band Apply Tube & O-Ring Seals
G04846215Courtesy of SUZUKI OF AMERICA CORP.
  1. Install the 2 third gear band apply tube O-ring seals (53).
  2. Install the third gear band apply tube (52).
  3. If needed, lightly seat the third gear band apply tube into the transmission case assembly with a soft mallet.
    Fig 2: Identifying Third Gear Band Apply Tube Retainer
    G04846216Courtesy of SUZUKI OF AMERICA CORP.
  4. Install the third gear band apply tube retainer (51).
    CAUTION: Refer to FASTENER NOTICE .
  5. Install the 2 - M6 x 1.0 x 14 mm third gear band apply tube retainer bolts (50).

    Tightening torque 

    Tighten the third gear band apply tube retainer bolts to 5 N.m (44 lb in)  .

    Reference: TRANSMISSION FLUID BAFFLE INSTALLATION .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.