SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 11 (CHARGING SYSTEM)REPAIR INSTRUCTIONSBATTERY CURRENT SENSOR REPLACEMENTINSTALLATION PROCEDURE
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Installation Procedure

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Battery Current Sensor
G04843491Courtesy of SUZUKI OF AMERICA CORP.
  1. Squeeze the negative battery cable branches together.
    NOTE: Ensure the battery current sensor is installed in the correct direction and location on the negative battery cable.
  2. Slide the NEW battery current sensor (1) up onto the negative battery cable to the location previously marked during removal.
  3. Wrap electrical tape around the battery current sensor leg in order to secure the sensor to the negative battery cable.
  4. Install the negative battery cable clip to the cable to the locations previously marked during removal.
  5. Install the negative battery cable. Refer to INSTALLATION PROCEDURE .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.