Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013KIZASHI SPORT GTS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 72 (KEYLESS START SYSTEM)DIAGNOSTICS INFORMATION AND PROCEDURESSCAN TOOL UTILITY TABLE
2013 Suzuki Kizashi Sport GTS, FWD
Scan Tool Utility Table
2013 Suzuki Kizashi Sport GTS, FWDSECTION Scan Tool Utility Table
WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
SUZUKI scan tool has setting change function of keyless start control module as follows. For more information, refer to SUZUKI Scan Tool Operator's Manual.
SCAN TOOL UTILITY CHART
| Item | Setting | Description |
|---|---|---|
| Keyless Start System | ON/OFF | Setting of each inside and outside antenna (radio wave transmission allowed/not allowed) is changed. |
| Answer-back (Outside buzzer) | ON/OFF | Setting (active/passive) for outside warning buzzer during answer-back is changed. |
| Remote Controller Area Warning | ON/OFF | Setting (active/passive) for warning buzzer (in combination meter) during remote controller out of detection area alarm is changed. |
| Remote Controller Battery Warning | ON/OFF | Setting (active/passive) for remote controller battery run down warning is changed. |
| Security Alarm | ON/OFF | Setting (active/passive) of security alarm is changed. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.